Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Florence-Graham, CA
Chimney repair in Florence-Graham usually starts with an inspection, because most of the chimneys here belong to 1920s-1950s stucco bungalows and duplexes that haven’t burned a real fire in years. What we find in Florence-Graham is rarely a creosote problem. It’s cracked mortar crowns, missing caps, and flues blocked with palm fronds, leaves, and bird nests from the neighborhood’s mature palms and ficus trees. If you’ve got a chimney that hasn’t been looked at in a decade, call (833) 958-8849 and we’ll tell you exactly what’s going on inside it.
Why Florence-Graham Homes Are Different
Florence-Graham is an unincorporated LA County pocket of early-20th-century working-class homes, and that changes the chimney work we do. Most “chimneys” here are aging masonry flues tied to old gravity furnaces or decorative fireplaces that haven’t seen a real fire in years. The warm, dry basin climate means flues sit idle for long stretches, and idle flues collect things: bird nests, leaf litter, rodent debris, and the palm fronds that drop from every other yard on these dense blocks. When winter rain does show up, or a Santa Ana wind event pushes through, uncapped chimneys take on water and pests. The housing stock runs to single-story stucco bungalows and small duplexes, and the original brick and block chimneys on those homes often have cracked crowns and missing screen caps. That’s the Florence-Graham chimney profile: not creosote-soaked, but neglected, debris-loaded, and weather-exposed. Chimney work here is about inspection first, cleanup second, and structural repair third.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Florence-Graham Services
Most Florence-Graham homeowners call us for one of two reasons: they want the chimney swept and inspected, or they want the dryer vent cleaned before it becomes a problem. Both are core services for us, not add-ons.
Chimney Sweep in Florence-Graham
A sweep in Florence-Graham is often an idle-flue cleanup rather than a creosote removal. We open the flue, pull out whatever’s accumulated (palm fronds are common, so are bird nests and old mortar debris), and run a camera through to check for cracks or gaps. If you haven’t used your fireplace in years, that’s exactly when you should have it checked, because animal entry and water damage happen quietly. For the full rundown on what a sweep covers here, see Chimney Sweep in Florence-Graham.
Dryer Vent Cleaning in Florence-Graham
Dryer vents in Florence-Graham’s older homes are often long, narrow, and routed through tight wall cavities, and lint builds up fast. A blocked dryer vent is a fire hazard you can’t see: the lint sits inside the wall, the dryer runs hotter, and the exhaust has nowhere to go. We treat dryer vent cleaning as a core safety service, not an upsell, and we use the same camera-inspection approach we use on chimneys. Details on what a Florence-Graham dryer vent cleaning involves are on the Dryer Vent Cleaning in Florence-Graham page.
Chimney Repair in Florence-Graham
Chimney repair in Florence-Graham usually means fixing what decades of idle neglect and basin weather did to a 1920s-1950s masonry flue. The typical call starts with water staining on a ceiling near the chimney, a cap that’s rusted through or missing entirely, or a flue that’s been blocked by a bird’s nest for who knows how long. The homes here were built with original brick and block chimneys, and between the occasional winter rain, the Santa Ana winds, and the simple passage of time, mortar crowns crack and flashing pulls away. That’s where our Chimney Repair work starts: we inspect, we show you the camera footage, and we fix what actually needs fixing with materials built for the job.
Chimney Cap Installation
Signs you need it
You need a cap if birds, leaves, or palm fronds keep getting into your flue, or if you can see daylight where a cap should be.
What it costs in Florence-Graham
Chimney cap installation in Florence-Graham typically runs $250 – $520 depending on flue size and material.
How we do it
We measure the flue opening, set a properly sized stainless or copper cap, secure it through the crown, and verify the draft before we leave.
Chimney Cap Replacement
Signs you need it
A rusted, warped, or missing cap is a direct path for rain and animals, and replacement is almost always cheaper than the water damage it prevents.
What it costs in Florence-Graham
Chimney cap replacement in Florence-Graham follows the same range, about $250 – $520, with a little more if the old cap was improperly installed and the crown needs spot repair.
How we do it
We remove the damaged cap, check the flue tile and crown underneath, and install a new cap sized to the flue rather than forcing a universal fit.
Chimney Liner Installation
Signs you need it
Cracked flue tiles, an old unlined masonry flue, or a chimney converted to a gas furnace all call for a liner.
What it costs in Florence-Graham
Chimney liner installation in Florence-Graham generally runs $2,500 – $5,800, with the final number driven by flue height, diameter, and whether we need to break out the old tile first.
How we do it
We spec the right liner for the appliance venting through it, run it down the existing flue, insulate as needed, and reconnect the appliance to a properly sized termination.
Chimney Flashing Repair
Signs you need it
Water stains on the ceiling near the chimney or dampness in the attic after rain are the classic signs that flashing has separated or corroded.
What it costs in Florence-Graham
Chimney flashing repair in Florence-Graham typically costs $300 – $750, more if we’re rebuilding the mortar crown at the same time.
How we do it
We cut back the old flashing, install new step and counter flashing with proper overlap, seal the joint with a polyurethane sealant, and verify the water path is broken.
What Chimney Repair Costs in Florence-Graham
| Item | Typical range in Florence-Graham |
|---|---|
| Chimney cap installation | $250 – $520 |
| Chimney flashing repair | $300 – $750 |
| Chimney liner installation | $2,500 – $5,800 |
How long does chimney repair take in Florence-Graham?
A cap replacement or flashing repair is typically done in a single visit, under two hours. Liner installation usually runs half a day to a full day from setup through final draft check. Call (833) 958-8849 to schedule a look before winter rain starts.
Can you repair an old unused chimney, or does it need a rebuild?
Most Florence-Graham chimneys we see have plenty of good structure left. We tell you what actually needs replacing based on camera footage, and if a partial rebuild is warranted, we tell you that plainly. No scare selling, just what the flue shows us.
Brands We Service in Florence-Graham
We work with a vetted set of professional chimney and ventilation brands so Florence-Graham homeowners aren’t stuck with hardware-store parts. That includes our brands like DuraFlex liner systems, Famco caps and terminations, and HeatShield ceramic resurfacing. Parts for the common repairs are usually on the truck or a day out.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Florence-Graham, CA
| Service | Typical range in Florence-Graham |
|---|---|
| Chimney sweep (inspection included) | $149 – $280 |
| Chimney repair (cap, flashing, small masonry) | $250 – $750 |
| Chimney liner installation | $2,500 – $5,800 |
| HeatShield ceramic resurfacing | $2,200 – $4,500 |
| Dryer vent cleaning | $125 – $250 |
What pushes a price up in Florence-Graham: original masonry that’s never been opened, old clay flue tiles that need to be broken out, or a long run of flex vent between the dryer and the wall. What we promise: you get a flat price before we start, and if we find something extra, you hear about it and you approve it before we touch it.
Neighborhoods We Serve in Florence-Graham
We cover the full 90001 ZIP and the tight grid of residential blocks that define Florence-Graham. Most jobs we book in the area are within 20 to 30 minutes of our South Gate shop, so scheduling is flexible and return trips for parts are quick. We regularly work in:
- Graham corridor
- Florence-Firestone blocks
- Zamora Park area
- Miracle Mile side streets
- Central Florence-Graham
Service Area – Cities Near Florence-Graham
Our service area stretches beyond Florence-Graham into the surrounding Southeast LA County cities. We work regularly in Huntington Park, CA, South Gate, CA, Lynwood, CA, and over in Boyle Heights, CA. If you’re on the edge of Florence-Graham or just across a city line, call (833) 958-8849 and we’ll sort out whether you’re in range.
Serving Florence-Graham, CA – Our Local Coverage Area
We’re based in the Florence-Graham area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Florence-Graham
Most Florence-Graham appointments are booked within a few days, and because the shop is in South Gate, we can typically route a truck over the same week you call. If you’ve got water actively coming in, call (833) 958-8849 and ask about earlier openings.
Most chimney sweeps and cap or flashing repairs don’t require a permit, but liner installation or structural rebuilds can. We’ll tell you if your repair crosses the permit line and what the county will want to see before the work is done.
We serve Florence-Graham proper in the 90001 ZIP and all the neighboring Southeast LA County cities, including Huntington Park, South Gate, Lynwood, and Boyle Heights. If you’re just outside the boundary, call and we’ll confirm coverage before you book.
Both. Many Florence-Graham chimneys vent old gravity furnaces rather than wood-burning fireplaces, and we work on those flues all the time. The inspection process is the same: camera down the flue, honest report, no invented problems.
If your Florence-Graham chimney’s been ignored for a decade, start with a call to (833) 958-8849. We’ll send a technician who knows these old masonry flues, shows you camera proof of anything we recommend, and gives you a flat price before the work starts.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Florence-Graham Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Chris Doyle"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Katie Gallagher"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
- Rosa Rodriguez